Sc、Ce掺杂CrSi2的电子结构与光学性质的第一性原理

采用基于密度泛函理论的第一性原理赝势平面波方法对Sc、Ce单掺和共掺后CrSi₂的几何结构、电子结构、复介电函数、吸收系数和光电导率进行了计算。结果表明:Sc、Ce掺杂CrSi₂的晶格常数增大,带隙变小。本征CrSi₂的带隙为0.386 eV,Sc、Ce单掺及共掺CrSi₂的禁带宽度分别减小至0.245 eV、0.232 eV、0.198 eV,费米能级均向低能区移动进入价带。由于Sc的3d态电子和Ce的4f态电子的影响,Sc、Ce掺杂的CrSi₂在导带下方出现了杂质能级。掺杂后的CrSi₂介电函数虚部第一介电峰峰值增加且向低能方向移动,说明Sc、Ce掺杂使得CrSi₂在低能区的光跃迁强度增强,Sc-Ce共掺时更明显。Sc、Ce掺杂的CrSi₂吸收边在低能方向发生红移,在能量大于21.6 eV特别是在位于31.3 eV的较高能量附近,本征CrSi₂几乎不吸收光子,Sc单掺和Sc-Ce共掺CrSi₂吸收光子的能力有所增强,并在E=31.3 eV附近形成了第二吸收峰。说明掺杂Sc、Ce改善了CrSi₂对红外和较高能区光子的吸收。在小于3.91 eV的低能区掺杂后的CrSi₂光电导率增加。在20.01 eV<E<34.21 eV时,本征CrSi₂光电导率为零,但Sc、Ce掺杂后的体系不为零,掺杂拓宽了CrSi₂的光响应范围。研究结果为CrSi₂基光电器件的应用与设计提供了理论依据。     

Visible-light-induced,autopromoted nickel-catalyzed three-component arylsulfonation of 1,3-enynes and mechanistic insights

Science China Chemistry - A light-induced, nickel-catalyzed three-component arylsulfonation of 1,3-enynes in the absence of photocatalyst is reported. This methodology exhibited mild conditions,...     

Exact solutions of an asymmetric double well potential

Journal of Mathematical Chemistry - The analytical solutions of an asymmetric double well potential $$V(x)=a\, x^2-b\, x^3+c\, x^4$$ are found to be a triconfluent Heun function $$H_{T}(\alpha ,...     

基于抛光基材的热蒸镀铜箔生长高平整单层石墨烯薄膜

在石墨烯的化学气相沉积工艺中,铜箔是决定石墨烯薄膜质量的重要因素。传统铜箔由于制备工艺的限制,存在大量的缺陷,导致石墨烯薄膜的成核密度较高。本工作选用抛光铝板、抛光不锈钢板、微晶玻璃和SiO₂/Si作为基材,用热蒸镀法制备了不同粗糙度的铜箔,并详细讨论了以该系列铜箔生长高平整度石墨烯薄膜的条件及铜箔对石墨烯薄膜品质的影响。实验结果表明,铜箔以(111)取向为主,与基材分离后,表面具有纳米级平整度。在生长石墨烯后,从SiO₂/Si剥离的铜箔成核密度是4种基材中最小的。同时,从SiO₂/Si剥离的铜箔晶体结构变化最不明显,具有良好的结晶性,表面几乎不存在铜晶界缺陷。当压强为3 000 Pa,氢气和甲烷流速分别为300 mL/min和0.5 mL/min时,可以获得约1 mm横向尺寸的石墨烯单晶晶畴。     

部分还原氧化石墨烯的制备、 表征及对人宫颈癌HeLa细胞的体外杀伤作用

以氧化石墨烯(GO)为原料, 利用温和方法制备了3种不同还原程度的部分还原氧化石墨烯pRGO₁, pRGO₂和pRGO₃(pRGO_1—3)； 利用傅里叶变换红外光谱(FTIR)、 拉曼光谱(Raman)、 X 射线光电子能谱(XPS)、 紫外-可见光谱(UV-Vis)、 透射电子显微镜(TEM)和 EDS能谱对其结构和形貌进行了表征. 细胞实验结果表明, 无激光照射下pRGO_1—3本身的细胞毒性较低; 近红外(NIR)激光照射下pRGO_1—3通过光热和光毒性双重作用杀伤肿瘤细胞. 实验结果显示了pRGO 在肿瘤光热疗法和光动力疗法领域的应用潜力.     

Revealing the Effect of Surface Composition on Multiwalled Carbon Nanotubes Supported Pt-Fe Alloy Electrocatalysts for Methanol Oxidation Performance

The designs of efficient and inexpensive Pt-based catalysts for methanol oxidation reaction (MOR) are essential to boost the commercialization of direct methanol fuel cells. Here, the highly catalytic performance PtFe alloys supported on multiwalled carbon nanotubes (MWCNTs) decorating nitrogen-doped carbon (NC) have been successfully prepared via co-engineering of the surface composition and electronic structure. The Pt₁Fe₃@NC/MWCNTs catalyst with moderate Fe³⁺ feeding content (0.86 mA/mg_Pt) exhibits 2.26-fold enhancement in MOR mass activity compared to pristine Pt/C catalyst (0.38 mA/mg_Pt). Furthermore, the CO oxidation initial potential of Pt₁Fe₃@NC/MWCNTs catalyst is lower relative to Pt/C catalyst (0.71 V and 0.80 V). Benefited from the optimal surface compositions, the anti-corrosion ability of MWCNT, strong electron interaction between PtFe alloys and MWCNTs and the N-doped carbon (NC) layer, the Pt₁Fe₃@NC/MWCNTs catalyst presents an improved MOR performance and anti-CO poisoning ability. This study would open up new perspective for designing efficient electrocatalysts for the DMFCs field.     

自掺杂SnO2微球的水热合成及其可见光催化性能

本研究采用水热法,以柠檬酸为螯合剂,通过控制n(Sn⁴⁺)/n(Sn²⁺)的数值,合成了由具有丰富氧空位的SnO₂纳米晶体组装成的微球。通过X射线衍射(XRD)、扫描电子显微镜(SEM)、透射电子显微镜(TEM)、傅里叶红外光谱(FT-IR)、X射线光电子能谱(XPS)及UV-Vis漫反射光谱对SnO₂纳米微球进行表征分析,结果表明:在酸性水热条件和柠檬酸的螯合作用下,二氧化锡纳米晶体聚集形成微球;在Sn⁴⁺/Sn²⁺摩尔比例为3:7时,其微球尺寸最小,整体分散性较好;同时适量二价锡离子的掺杂使得该样品氧空位浓度达到最佳,氧空位的存在将使得样品光吸收范围拓展至可见光,因而该样品显示出较强的可见光催化效率,在8 min内完全降解甲基橙。     

Electrochemiluminescence Enhanced by the Synergetic Effect of Porphyrin and Multi-walled Carbon Nanotubes for Uric Acid Detection

The design and exploration of efficient, stable and environmentally compatible organic emitters for an electrochemiluminescence (ECL) sensor is a promising topic. Herein, a novel environmentally-friendly luminophore, ZnBCBTP@MWCNTs, were fabricated via self-assembly of porphyrin molecules (ZnBCBTP) onto multi-walled carbon nanotubes (MWCNTs). The resulting luminophore ZnBCBTP@MWCNTs displayed not only the highly ECL property and but also the good accelerated electron mobility. Then, a label-free ECL biosensor based ZnBCBTP@MWCNTs was constructed for the ultrasensitive detection of uric acid. Excitingly, this proposed ECL biosensor performed a good linear relationship in the range of 0–300 μM with a low detection limit of 1.4 μM, thus offering another reliable and feasible sensing platform for clinical bioanalysis with good selectivity, stability, and repeatability.     

How do peace dividends bring about human development and productivity?

Annals of Operations Research - The main purpose of this study was to explore the impact of peace dividends on global changes in national productivity. First, this study assessed changes in...     

Mechanistic Investigation and Conductance Modulation of a Metal-Molecule-Metal Junction via Extra Acid Addition

One important prerequisite for the fabrication of molecular functional device strongly relies on the understanding the conducting behaviors of the metal-molecule-metal junction that can respond to an external stimulus. The model Lewis basic molecule 4,4′-(pyridine-3,5-diyl)dibenzonitrile (DBP), which can react with Lewis acid and protic acid, was synthesized. Then, the molecular conducting behavior of DBP, DBP-B(C₆F₅)₃, and DBP-TfOH (DBP-B(C₆F₅)₃, and DBP-TfOH were produced by Lewis acid and protonic acid treatment of DBP) was researched and compared. Given that their identical physical paths for DBP, DBP-B(C₆F₅)₃, and DBP-TfOH to sustain charge transport, our results indicate that modifying the molecular electronic structure, even not directly changing the conductive physical backbone, can tune the charge transporting ability by nearly one order of magnitude. Furthermore, the addition of another Lewis base triethylamine (of stronger alkaline than DBP), to Lewis acid-base pair reverts the electrical properties back to that of a single DBP junction, that is constructive to propose a useful but simple strategy for the design and construction of reversible and controllable molecular device based on pyridine derived molecule.